How Often Should You Change Vape Coils? Signs It's Time to Replace Them

How Often Should You Change Vape Coils?

Vape coils are one of the most important parts of any vape device. The coil is responsible for heating the e-liquid and turning it into vapour. Over time, however, vape coils wear out and need to be replaced.

Most vapers will need to change their coil every 5 to 14 days, although this can vary depending on usage, device type and the type of e-liquid used.

Knowing when to replace your vape coil helps maintain good flavour, prevents burnt hits and ensures your vape continues to work properly.


Typical Vape Coil Lifespan

The lifespan of a vape coil depends on several factors, including how often you vape and what type of e-liquid you use.

For most people, vape coils last:

  • Light vapers: 10–14 days

  • Moderate vapers: 7–10 days

  • Heavy vapers: 5–7 days

Some coils may last longer if they are used carefully and properly maintained.


Signs Your Vape Coil Needs Replacing

Over time you will start to notice certain signs that your coil is reaching the end of its lifespan.

Burnt Taste

One of the clearest signs that a coil needs replacing is a burnt taste when vaping. This happens when the cotton wick inside the coil begins to burn.

Once a coil tastes burnt, it usually cannot be fixed and should be replaced.


Weak Flavour

If your e-liquid suddenly tastes dull or weak, the coil may no longer be heating the liquid properly.

Replacing the coil will normally restore flavour immediately.


Reduced Vapour Production

Another sign that your coil may need changing is reduced vapour production. As coils age, they become less efficient at heating e-liquid.

This can result in smaller clouds and less satisfying vaping.


Gurgling or Leaking

Old coils can sometimes cause flooding or gurgling sounds inside the tank. This happens when the wick becomes saturated unevenly or begins to break down.

Replacing the coil can often fix these issues.


What Causes Vape Coils to Burn Out Faster?

Several factors can reduce the lifespan of a vape coil.

Sweet E-Liquids

Many sweet e-liquids contain flavourings that leave residue on the coil. This residue builds up over time and can cause coils to burn out faster.


High Wattage Settings

Using a wattage higher than recommended for your coil can cause it to overheat. This damages the cotton wick and shortens coil life.

Always check the recommended wattage range printed on your coil.


Chain Vaping

Taking multiple puffs in quick succession can prevent the cotton wick from absorbing enough e-liquid between draws. This may cause dry hits and premature coil damage.

Allowing a few seconds between puffs can help protect your coil.


How to Make Vape Coils Last Longer

While coils eventually need replacing, there are several ways to extend their lifespan.

Prime new coils properly

Always prime new coils before using them to prevent dry hits.


Use the correct wattage

Keeping your device within the recommended wattage range prevents overheating and prolongs coil life.


Keep your tank filled

Allowing the tank to run dry can burn the coil instantly. Always keep enough e-liquid in the tank to saturate the wick.


Avoid chain vaping

Taking slower puffs allows the wick to absorb more liquid between draws.


Replacing a Vape Coil

Replacing a vape coil is simple and only takes a few minutes.

  1. Remove the tank from your device

  2. Unscrew the old coil

  3. Install the new coil

  4. Prime the coil with e-liquid

  5. Refill the tank and allow it to sit for several minutes

Once the new coil is installed, your vape should produce clean flavour and smooth vapour again.


Final Thoughts

Changing vape coils regularly is essential for maintaining the performance of your vape device. Most coils last between one and two weeks, but factors such as wattage, e-liquid type and vaping habits can affect their lifespan.

By recognising the signs of a worn-out coil and replacing it when needed, you can ensure your vape continues to deliver great flavour and vapour.


Related Guides

You may also find these helpful:

Back to blog